Used in golf simulators to stop the ball after you hit it and to provide a surface to project an image.
    3 products


    The screen will have some creases which will even out over time once it has been installed.

    1. ONLY Use white balls without dirt, grass or marker on them. Even branded balls can transfer to the screen.
    2. ONLY Use new golf balls. Nicks or abrasions on the surface of the ball will accelerate normal wear.
    3. ONLY Use clean clubs. Dirt can transfer to the ball and mark the screen - it will also benefit parts of your game like ball spin.
    4. Store your screen in a safe, clean and dry environment - if you ever need to pack it away.

    The spin of the golf ball does create marking on the screen. This is normal and should not be highly visible when an image is projected onto the screen.

    Most minor stains on your golf impact screen can be cleaned with a drop of mild dish soap on a damp cloth to spot clean the area.

    We suggest a minimum of 30-40cm between the rear wall and your screen.

    For longevity the further from the screen you are the better and we recommend 3m, but you can comfortably stand up to 2.4m away from the screen.


    Height: 3m

    We can not go higher unless you are willing to have a seam in the screen).

    Width: 3m or 4m

    Depending on your projector you may be able stretch your projected image to fill a 3mx3m square screen. Projection is 16:9, so we recommend a width of 4m for the best fit.


    We can provide you with a custom screen size (we have done up to 6m wide by 3m high).

    *We will contact you prior to ordering your screen to confirm the measurements.